Differential Pulse Code Modulation And Demodulation Trainer
Model No. HV-EXP2217
Experimental training board has been designed specifically to study differential pulse code modulation & demodulation. In the basic DPCM Modulator the base band analog signal is covered into 8bit digital format using an ADC. The sampling rate is set at 2.5 Khz.The DPCM demodulator receives the serial data, converts it into 8bit parallel format. The Digital to Analog converter transforms the 8bit parallel data into analog level. Thus the output of DAC is astepped approximation of input signal. Alow pass filter is used to recover the analog signal. Practical experience on this board carries great educative value for science and engineering students.Object:To study differential pulse code modulation & demodulation.Features:The board consists of the following built-in parts : 5V D.C. at 100mA IC regulated power supply internally connected. ± 12V D.C. at 100mA IC regulated power supply internally connected. -5V D.C. to +5V D.C. Variable D.C. output. Audio Frequency Oscillator 10Hz to 100Hz for modulation. DPCM Modulator (DPCM ENCODER). DPCM Demodulator (DPCM DECODER). Adequate no. of other electronic components. Mains ON/OFF switch, fuse and jewel light. The unit is operative on 230V ±10% at 50Hz A.C. Mains. Adequate no. of patch cords stackable from rear both ends 4mm spring loaded plug length ½ metre. Good Quality, reliable terminal/sockets are provided at appropriate places on panel for connections /observation of waveforms. Strongly supported by detailed Operating Instructions, giving details of Object, Theory, Design procedures, Report Suggestionsand Book References. Weight :3Kg. (Approx.) Dimension :W340 xH110 xD210 OTHER APPARATUS REQUIRED*Dual Trace Cathode Ray Oscilloscope 20MHz.....
E: info@hoverexport.com w: www.hoverexport.com M: +91 94666 93111